Taski CO150.5 Translation Of The Original Instructions Of Use

31
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 tr sv sl pt pl no nl it fr fi es en de da cz
End of operation
Emptying the tank
Cleaning the tank
Wash out the motor protection filter
Washing out the filter housing and the float
• Press the suction switch (1) to turn the suction
unit on (no lamp)
• Press the water pump switch (2) to turn the
water pump on (lamp lights up).
Caution:
If the red control display „brush pressure“ lights up, correct the
brush height as described below.
• Adjust the brush height by turning the regulator
until the green displaay lights up.
LED display Status indicator
Display green Brush height correctly adjusted
Display red Correct the brush height. Turn the adjustment button
to the right for more, or to the left for less brush
pressure.
• Switch the water pump off (1).
• Allow the suction unit to run for a further 10
seconds so that the rest of the water is sucked
up.
• Switch the suction unit off (2).
• Switch the machine off (main (ON/OFF) switch
+ pull out plug).
• Lock the machine in the vertical position.
• Wind the power cord around the cable hook.
Caution:
Switch the machine off (main ON/OFF switch and plug) when
carrying out work on the machine!
• Remove the tank from the machine by
pulling on the tank unlocking device (1).
Hold the tank (2) with your other hand so that it
does not fall out of the holder when unlocked
and pull the solution tank out of the holder.
1
2
MAX
BRUSH PRESSURE
MIN
RED
GREEN
1
2
2
1
• Empty the soiled solution from the tank through
the opening provided on the rear side of the
tank.
• Remove the filter housing from the tank. To do
this, open the unlocking device on the rear side
of the tank.
• Rinse out the tank with water and clean it with a damp cloth.
• Remove the motor protection filter from the
transparent filter protection above the filter
housing.
• Wash the motor protection filter under running
water.
• After washing it, wring out the motor protection
filter so that the water can flow out.
Caution:
Do not reinstall the motor protection filter before it has completely
dried out.
• Remove the motor protection filter from the filter protection before washing
out the filter housing.
• Wash out the filter housing and the float (X),
which is located on the underside of the filter
housing, under running water.
• Reinstall the dry motor protection ffilter.
• Place the filter housing on the tank and lock it
(see page 30)
1
2
x
2
1

Taski CO150.5 Specifications

General

Brand	Taski
Model	CO150.5
Category	Floor Machine
Language	English