75
Working backwards
Function change
Transport over stairs
• Start at the wall where the socket is located.
• Pull the machine backwards.
• Stop the brush and spray functions approximately 30 cm
before the strip ends.
• Move the machine to the beginning of the next strip.
Notice:
Strips should overlap 3 cm to ensure
cleaning of the entire carpet.
Attention:
If you switch between function I and func-
tion II, you must rinse both tanks thorough-
ly.
Notice:
The machine must only be transported
over stairs by two persons.
• Switch off the machine.
• Remove the plug from the mains socket.
Attention:
Lifting the machine can be dangerous un-
der any circumstances!
Stumbling may cause personal injuries or
machine damage.
Attention:
Both the fresh water and the recovery tank
must be emptied completely before lifting
the machine.
EN
To Next Page
Loading...
