90
Power off function
During these 5 minutes:
Battery capacity - end of operational readiness
The battery level indicator provides information on the avail-
able operating time.
• If the red indicator begins to flash, approx. 5 minutes of
residual working time are left.
• After that the brush unit is lifted. The red display switches
to continuous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Replenishing cleaning solvent
Draining dirty water
Recovery tank full:
End of operation
Variant: Automatic brush lowering (Option 1255B)
• Drive on for a few meters in order to absorb the remaining
drain water.
Variant: Foot pedal
Notice:
TASKI offers an automatic dosage feature
as an option. It is possible to mount it addi-
tionally. Please contact your customer ser-
vice.
• By gently pushing the driving switch
into the direction of movement the
machine is set into motion.
Notice:
The machine turns itself off after 5 minutes
when no longer in use.
• the brushes may not be manipulated in any way.
• the user must not leave the machine out of sight.
• sucked in or jammed objects may be cleaned from the
squeegee only.
• the user is only allowed to leave the machine in order to
clear the work space. The user must maintain visual con-
tact.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.
Attention:
The flooring may be damaged when work-
ing without cleaning solution.
Notice:
A rattling sound of the pump indicates that
the fresh water tank is empty.
Attention:
The pump must never run dry for an ex-
tended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 88.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 91.
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive button ON/
OFF.
The display lights up and the brush
unit is stopped and lifted.
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
To Next Page
Loading...
Need help?
General