Taurus PTSI 2200 - Dry Ironing; Steam Ironing; Steam Control Features; Vertical Steaming

perature position.
- Do not use temperatures higher than those
indicated on the garments to be treated.
- ● Temperature for synthetic bres (Polyester,
Nylon…).
- ●● Temperature for silk, wool.
- ●●● Temperature for cotton, linen. (Minimum
temperature for steam ironing)
- If garment has various kinds of bres, select the
temperature for the bre that requires the lowest
temperature. (For example, select the tempera-
ture for polyester for an article made out of 60%
polyester and 40% cotton).
- Wait until the pilot light (D) has gone out which
will indicate that the appliance has reached an
adequate temperature.
- During use the pilot light (D) will automatically
ash on and o󰀨, thus indicating that the heating
elements are operating in order to maintain the
desired temperature.
DRY IRONING:
- The appliance has a steam ow regulator (C)
that permits dry ironing (without steam) when
placed in the 0 position.
STEAM IRONING:
- It is possible to iron with steam whenever the
deposit is lled with water and the adequate
temperature is selected.
STEAM FLOW CONTROL:
- The appliance has a (C) control knob that allows
to get the control of the steam ow.
SPRAY:
- The spray can be used in both steam and dry
ironing.
- Press the spray button ( A ) to use this opera-
tion.
- The spray button has to be pressed repeatedly
to release the rst spray.
STEAM BLAST:
- This function proportions extra steam for elimi-
nating wrinkles.
- Press the steam blast button (B). Wait a few
seconds until vapour penetrates the bres of the
garment before pushing the button again. For
optimum steam quality, do not apply more than
three successive blasts.
- The spray button has to be pressed repeatedly
to release the rst spray.
VERTICAL STEAMING
- It is possible to iron hanging curtains, items of
clothing on his hanger, etc. To do so, follow the
instructions:
- Select the maximum temperature of the iron,
while turning the temperature regulator of the
iron in a clockwise direction (Fig 2).
- Move the iron in a top to bottom direction while
pressing the steam control ( B ). Important: for
cotton and linen, its recommended to put the
iron base in contact with the material. For other
more delicated bres, it’s recommended to keep
the iron base at some centimetres of distance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
CLEANING
- Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
SELF-CLEANING FUNCTION:
- It is important to self-clean the appliance at least
once a month to remove calcium and any other
built-up minerals inside the iron.
- Fill the depository to its maximum level, as
indicated on “water ll” section.
- Place the iron in a vertical position, plug in to
the mains and select the maximum temperature.
- Leave the appliance to heat up until the pilot
light indicates that it has reached its consigned
temperature.
- Unplug the appliance and place in the sink.
- Press the self-clean button, and keep it pressed
down.
- Let the water ow out through the steam vents
in the base, while lightly shaking the appliance.
- Release the button after a minute or when the