EasyManuals Logo

Taurus STRIKER 2.0 User Manual

Taurus STRIKER 2.0
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
directly affecting battery life.
- Make sure that the On/Off switch is set to “0”
before tting the batteries.
- Remove the cover of the battery compartment.
- Put the battery in its compartment, respecting
the polarity (Fig. 2).
- Close the cover of the
- battery compartment.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance’s protective lm.
- Make sure that all the product’s packaging has
been removed.
- Before using this product for the rst time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use.
ASSEMBLING THE SIDE BRUSHES:
- Fit the side brush onto the side brush support.
- Press until it clicks. (Fig.3).
ASSEMBLING THE MOP:
- Stick the mop onto the mop holder (Fig. 4a).
- Adjust the chamois support on the body’s an-
chor points. (Fig.4b).
- Remove the chamois support if the robot is
going to be used without a chamois.
USE:
- Once the appliance is charged, use the On/
Off switch on the side of the robot to start the
appliance, and press the ON/OFF button on the
top of the robot.
- The appliance will start to work automatically
until its batteries are exhausted.
- The red low-battery indicator will light up while
the appliance is running.
- Remove the chamois stand before using the
robot on carpets or rugs.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Use the On/Off switch on the side of the robot
to stop the appliance, and press the ON/OFF
button on the top of the robot.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Clean the appliance
CLEANING
- Disconnect the charger from the mains and let it
cool before undertaking any cleaning task.
- Remove the battery before starting any cleaning
operation.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- Never submerge the connector in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX:
- Empty the dust box each time after use.
- Open the lid of the dust box. (Fig.5)
- Disconnect the dust box from the appliance..
(Fig.6)
- Open the lid of the dust box,
- empty the contents into the appropriate waste
disposal receptacle.
- Check the condition of the dust box lter and
ret it.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
CHANGING THE FILTERS:
- It is recommended that the dust box lter should
be changed every three months.
- To remove the lters:
- Open the lid of the dust box. (Fig.5).
- Disconnect the dust box from the appliance.
- Open the dust box emptying lid and remove the
dust box lter from its bracket (Fig.7).
- To reassemble the lter, proceed with the above
instructions, in reverse order.
CLEANING THE CHAMOIS
- Pull on the chamois until it comes free (Fig. 8)
- The chamois can be washed with soapy water
or in the washing machine.
- To t the chamois, follow the instructions in the
previous section but in reverse order.
CHANGING THE SIDE BRUSHES:
- To remove the side brushes:
- Pull on the brush’s bristles so that the side

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taurus STRIKER 2.0 and is the answer not in the manual?

Taurus STRIKER 2.0 Specifications

General IconGeneral
BrandTaurus
ModelSTRIKER 2.0
CategoryVacuum Cleaner
LanguageEnglish

Related product manuals