EasyManua.ls Logo

Taurus TBS-350 - Operational Safety Practices; Workpiece Security and Tool Maintenance; Operational Precautions and Checks

Taurus TBS-350
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
After Sales Support TEL: 07 3188 2025 WEB: h e l p d e s k @d u o n s .c o m .a u
5Belt & Disc Sander
After Sales Support TEL: 07 3188 2025 WEB: h e l p d e s k @d u o n s .c o m .a u
- Never yank the cord to disconnect it from the socket. Keep the cord away from heat, oil
and sharp edges.
12 - Secure work
- Where possible use clamps or a vice to hold the work. It is safer than using your hand.
13 - Do not overreach
- Keep proper footing and balance at all times.
14 - Maintain tools with care
- Keep cutting tools sharp and clean for better and safer performance.
- Follow instruction for lubricating and changing accessories.
- Inspect tool cords periodically and if damaged have them repaired by an authorised
service facility.
- Inspect extension cords periodically and replace if damaged.
- Keep handles dry, clean and free from oil and grease.
15 - Disconnect tools
- When not in use, before servicing and when changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16 - Remove adjusting keys and wrenches
- Form the habit of checking to see that keys and adjusting wrenches are removed from the
tool before turning it on.
17 - Avoid unintentional starting
- Ensure switch is in off position when plugging in.
18 - Use outdoor extension leads
- When the tool is used outdoors, use only extension cords intended for outdoor use and so
marked.
19 - Stay alert
- Watch what you are doing, use common sense and do not operate the tool when you are
tired.
20 - Check damaged parts
- Before further use of tool, it should be carefully checked to determine that it will operate
properly and perform its intended function.
- Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that may affect its operation.
- A guard or other part that is damaged should be properly repaired or replaced by an
authorised service centre unless otherwise indicated in this instruction manual.
- Have defective switches replaced by an authorised service centre.
- Do not use the tool if the switch does not turn it on and off.
21 - Warning: The use of any accessory or attachment other than one recommended in this
instruction manual may present a risk of personal injury.
BGM6019 Ma 1112-13.indd 5 13-12-2011 08:44:46