Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
2
. When using a cable reel always unwind the reel
completely.
Technical specifications
Voltage 230 V ~
Frequency 50 Hz
Power input 350 W
No load speed sander belt 282 m/min
No load speed sander disc 1450 /min
Sanding belt size 915 X 100 mm
Sanding disc size Ø 150 mm
Weight 14.2 kg
Lpa (Sound pressure level) 75 + 3 dB(A)
Lwa (acoustic power) 88 + 3 db(A)
Vibration level
The vibration emission level stated in this instruction manual has been measured in
accordance with a standardised test given in EN 61029; it may be used to compare one tool
with another and as a preliminary assessment of exposure to vibration when using the tool for
the applications mentioned
- using the tool for different applications, or with different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when it is running but not actually doing the job,
may significantly reduce the exposure level
Protect yourself against the effects of vibration by maintaining the tool and its
accessories, keeping your hands warm, and organising your work patterns
ASSEMBLY
Installation
Avoid the use of long extension cables. If necessary, secure the sanding machine on a working
bench with help of screws through the holes in the feet of the machine frame. Do not forget to
leave enough space around the machine for the workpieces to be sanded.
To Next Page
Loading...