18
Controls
Model C009
081215
Programming the Portion Control
The C009 Taylor Non-Carbonated Beverage
Dispenser has been pre-programmed from the
factory to pour 12, 16, 21, and 32 oz. drinks. To
change portion sizes, follow the instructions below:
Teaching Cup Sizes - Programming
Finished Volumes
1. Press and hold the Extra Large portion button
and the Menu button of the appropriate
dispenser head.
2. Continue holding these buttons for five
seconds. After five seconds the Product Low
LED will start to flash.
3. Release both buttons. The Product Low LED
will flash at a one second rate while in the
Teaching Mode.
4. Place a small cup under the dispensing head.
5. Press and hold the Small portion button until
the cup is filled to the desired level. This button
can be repeatedly pressed and released to top
off the portion.
6. Repeat these steps for the medium, large, and
extra large cups.
7. Press the Menu key on the right side of the
dispenser to return to normal operation.
Note: This process is also used to clear any
pending error states.
Example: The left head service LED is red.
To clear this error state, press and hold the left head
Extra Large portion button followed by the Menu
button, for 5 seconds.
To Next Page
Loading...
Need help?
General
