26
Accumulator doors not
closing
(one or both accumulator
doors are out of place)
Drive wheel screw or clevis pin
has broken or detached.
Use the Accum parameter in the Test Outputs section of the
Service menu to manually operate the accumulator motor and
doors. If neither door operates or if the doors move only slightly,
suspect the drive wheel assembly. Verify by visually inspecting
the assembly inside the back panel. Use caution.
Broken accumulator spring. Use the Accum parameter in the Test Outputs section of the
Service menu to manually operate the accumulator motor and
doors. If the right-hand door opens and closes normally but the
left-hand door does not move, or moves very little, suspect the
accumulator door spring has broken.
Accumulator door retaining
screw is missing.
A door will be hanging loose; it can be either the right or left door.
Visually inspect the accumulator door assembly in the back. Use
caution.
Positioning information has
been lost.
Use the Accum parameter in the Test Outputs section of the
Service menu to manually operate the accumulator motor and
close doors. Refer to the Service menu section of the machine
manual. If doors return to open, reset Dispenser parameters
(defaults) using the Parameter function in the Clear Functions
section of the Service menu. Then use the Accum function to
close the doors. Finally, calibrate the Dispenser. See manual or
below for calibration instructions.
Fry loads are incorrect Calibration has been lost or
changed.
Calibrate the Dispenser. See below or manual for calibration
instructions.
Hopper parts are not correctly
assembled.
Verify hopper assembly and placement.
Does not dispense fries
into basket
(Accumulator doors are
not opening)
The fry load target weight has
not been met (low fry indicator).
Verify there are fries in the hopper and on the accumulator doors
waiting to be dispensed.
Check the hopper for bridging of the fries.
Verify the drum turns.
Basket is not lined up with the
basket sensor window.
The front end of the basket must be raised slightly and slid
forward to the basket sensor shroud.
Basket sensor is not reading
the basket or sending a signal
to the controller.
Remove any fries or other debris which may be interfering with
the basket reaching the sensor.
Disconnect and reconnect the basket sensor connector at the
controller.
Replaced the basket sensor if reconnecting the sensor
connection does not solve the problem.
Hopper not installed correctly. Inspect hopper for proper assembly and placement.
To Next Page
Loading...