OPERATING PROCEDURES
6-3
Models RD30/RC25
Operating Procedures
6
9. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: door
bearing, door gasket, draw valve, O-rings, and all
sides of the door assembly, including the inside of the
draw valve bore. Replace any damaged parts.
10. Slide the draw valve O-ring into the groove on the
draw valve and lubricate the O-ring.
Figure 6-10
11. Place the draw valve spring over the shaft end on the
draw valve.
Figure 6-11
12. Insert the draw valve and spring into the door spout
until the threaded end of the shaft passes through the
hole in the end of the door spout. Thread the draw
valve knob onto the end of the draw valve shaft.
Figure 6-12
13. Place the door spout seal O-ring into the groove in
the door and lubricate the components.
Figure 6-13
14. Align the draw spout assembly with the door. Place
the draw spout mounting plate over the draw spout
assembly and align the holes.
Figure 6-14
15. Using the thumb screws, fasten the draw spout
assembly and draw spout mounting plate to the door.
Figure 6-15
Apply the appropriate
Taylor approved food safe lubricant.
HP
Apply the appropriate
Taylor approved food safe lubricant.
HP
To Next Page
Loading...
Need help?
General
