6
SELECTING THE SCALE PLATFORM’S CHANNEL
To select the scale platform’s channel, first turn off the
scale base and wireless display units. Then use the dip switch,
which is located on the bottom of the scale under the rubber
stopper. The dip switch has four pins marked ‘1, 2, 3, 4’
(Pin-4 is not active; only 3 channels are available for use.)
To select a channel, move the pin toward the ‘ON’ mark
(pictured below). For example- To select Channel-1 for the
scale, move Pin-1 towards the ‘ON’ mark. Turn on the scale
base first, then the wireless display for use.
The dip switch is on the bottom of the scale platform under
the rubber stopper.
To Next Page
Loading...
