5 Operation
Operation via interface
The system can be controlled via remote control.
The following functions are available:
• “Filter saturated” (Filter gesättigt) display
• Switching between Run/Standby
• Speed control
The system can be controlled via the interface.
For details on the interface assignment, see “Interface” section.
The following functions are available:
• Filter full /Filter full inverted
• Run/standby
• Speed monitoring
• Temperature message
• External speed control
• Collective fault
• Cleaning mode activation
(For the scope of functions of your system, see interface options)
Message memory access.
Access to the message memory of the system is possible via the interface on systems in the
LN, GL and FP series.
(For the necessary software and adapter cable, see “Spare parts”)
Individual parametrisation according to specific application.
Systems from the LN, GL and FP series can be adapted to individual customer requirements
via the interface.
The following functions are available:
• Front panel on/off
• Min./max. power settings
• Fault shut-down on/off
• Select cleaning mode (FP systems)
• Select shut-down cleaning (FP system switches to cleaning mode in standby)
• System post-run
(For the necessary software and adapter cable, see “Spare parts”)
67-236
To Next Page
Loading...
