EasyManua.ls Logo

TCL 50 XE 5G - Radio Waves

TCL 50 XE 5G
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
6
For more information on our Battery Recycling Program, please visit the
USA and Canada at https://www.tcl.com/us/en/mobile/accessibility-
compliance/tcl-mobile-electronic-recycling-program.html/
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO
THE INSTRUCTIONS.
CHARGERS:
Home A.C./ Travel chargers will operate within the temperature range of:
0°C (32°F) to 40°C (104°F).
The chargers designed for your phone meet the standard for safety of
information technology equipment and oce equipment use. Due to
dierent applicable electrical specifications, a charger you purchased in
one jurisdiction may not work in another jurisdiction. They should be used
for this purpose only.
Characteristics of power supply (depending on the country):
Travel charger:9V2A QC13US
Input: 100-240V,50/60Hz, 0.5A
Output: 5V 3A/9V 2A/12V 1.5A
Battery: softpack 5010mAh typ
Radio waves
THIS PHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR
EXPOSURE TO RADIO WAVES.
Your phone is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to
radio-frequency (RF) energy. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general
population. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies. These guidelines include a substantial
safety margin designed to ensure the safety of all persons, regardless of
age and health.
The exposure standard for phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by public
authorities such as the Federal Communications Commission of the US
Government (FCC), or by Innovation, Science and Economic Development
Canada (ISEDC), is 1.6 W/kg averaged over 1 gram of body tissue. Tests
for SAR are conducted using standard operating positions with the phone
transmitting at its highest certified power level in all tested frequency
bands.
This device is complied with SAR for general population /uncontrolled
exposure limits in ANSI/IEEE C95.1-1992 and had been tested in
accordance with the measurement methods and procedures specified in
IEEE1528.
The FCC has granted an Equipment Authorization for this model phone
with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines. SAR information on this model phone is on file with
the FCC and can be found under the Display Grant section of www.fcc.
gov/oet/ea/fccid after searching on FCC ID: 2ACCJH179
Although the SAR is determined at the highest certified power level,
the actual SAR level of the phone while operating can be well below
the maximum value. This is because the phone is designed to operate
at multiple power levels so as to use only the power required to reach
the network. In general, the closer you are to a wireless base station
antenna, the lower the power output of the phone. Before a phone model
is available for sale to the public, compliance with national regulations and
standards must be shown.
The highest SAR value for this model phone when tested is 1.19 W/Kg for
use at the ear and 1.10 W/Kg for use close to the body.
While there may be dierences between the SAR levels of various phones
and at various positions, they all meet the government requirement for RF
exposure.
For body-worn operation, the phone meets FCC RF exposure guidelines
provided that it is used with a non-metallic accessory with the handset at
least 15 mm from the body.
Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
Additional information on SAR can be found on the Cellular
Telecommunications & Internet Association (CTIA) Web site:
http://www.ctia.org/

Related product manuals