6
EN
Handling and placement
Certain space shall be left
around the refrigerator,
shown in the figure.
>10cm
>10cm >10cm
<45°
The refrigerator shall be
placed on the flat and
firm surface. If the ground
is not flat, adjust the
adjusting leg to keep it
level.
During handling, the door
side of the refrigerator
shall not contact with the
handling tools
Never place the refrigerator
into a too cold environment
that may get frozen.
The refrigerator shall be
placed in an environment
which is dry, has good
ventilation, far from direct
sunshine and heat source.
Removing the foam base is
beneficial for bottom heat
dissipation and can avoid
fire.
Warm prompt:
--When handling the refrigerator, at least two persons are required — one lifts the top of
rear part, the other one handles the bottom (if one part is clamped, it is quite dangerous
and may cause accident).
--When moving the refrigerator, the lower runner may damage and scratch the floor. If you
need to move the refrigerator for a long distance, the internal accessories shall be fixed
using adhesive tape. Otherwise, the accessories may get damaged due to crashing each
other.
--Please place the refrigerator in the position with small vibration or little exposed to
vibration. For users in the area where earthquake often occurs, please fix the refrigerator
against the wall or pole. Otherwise, the falling of refrigerator will cause accident.
--Sufficient clearance shall be left around. If the clearance is too small or place goods on
the top or close to the side, or paste on the sides, the heat dissipation of refrigerator will
be affected, and thus to cause unnecessary electric energy waste as well as burn out of
the wall and other goods; the contact between the back and wall will cause vibration and
noise;
--Adjust the front part and adjusting leg of the refrigerator to level it. Unlevel of the
refrigerator will cause vibration and noise.