TCL Alcatel POP4-10 4G&VF - Page 17

L1 Service Manual TCL Communication Ltd.
Rev.
9030G/9030Q/VFD1400 Level 1 Service Manual
Page
1.1
17/26
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
the interface displaying the SW version. Select “Auto” to start the auto test, or select “MANU” to do
the MMI test manually.
If one of the tests failed during “Auto” test mode, it will display “Failed: xxx, Press „Next‟ to go on test;
Press „RETEST‟ to retest this item; Press „END‟ to Power off.”
 Battery Type
I. You can get information about Battery Type.
II. Press “pass” key to continue.
 Traceability
I. You can get information such as IMEI, BSN, BT, CU-REF, PTH, etc.
II. Press “pass” key to continue.
 RAW Data
I. You can see Raw data test is running and it will display “Test: Pass” if it functions well;
II. Press “pass” key to continue;
 Touch Panel
I. “Please draw in the yellow area” according to instructions
 LCD
I. You will see the LCD display three colors - RED, GREEN and BLUE - if it functions well;
II. Press “Pass” to continue.
III. You will see the LCD display greychart if it functions well.
IV. Press “Pass” to continue.
V. You will see the LCD display black if it functions well.
VI. Press “Pass” to continue.