TCL Alcatel POP4-10 4G&VF - Page 11

L2 Repair Document TCL Communication Ltd.
Rev.
9030G/9030Q/VDF1400
Level 2 Repair Document
Page
1.0
11/44
All rights reserved. Transfer, copy, use or communication of this file is prohibited without authorization.
I. Insert USB cable according to instruction, then it will say “USB:OK
Charger :OK” ;
II. Remove USB cable according to instruction
III. Press “Pass” to continue;
 G-Sensor
I. Put the handset towards up according to instruction;
II. Put the handset towards the directions indicated by instructions; it will say “All
positions checked” after you following all the directions if it if it functions well;
III. Press “Pass” to continue;
 SIM
I. Insert SIM card and the phone will detect it if functions well;
II. Press “Pass” to continue;
 Memory Card
I. Insert Memory card and the phone will detect it if functions well;
II. Press “Pass” to continue;
 Battery Temperature
I. It will display “Battery temperature should between: 20~50”, “current is xxx”
“Battery content should between: 40~60%”, “current is xxx”
“Battery Voltage is 4.289V”, “Battery Present is xxx” if it functions well;
II. Press ”Pass” to continue;
 Bluetooth
I. Bluetooth will search automatically and it will display device address if it
functions well;
II. Press ”Pass” to continue;
 Wifi
I. It will search for WIFI hotspot and display searched result on the screen if it functions well;