Install Washing Machine
■
Connect
the
inlet
hose
1.Connect the inlet hose to tap and
fasten it anticlockwise.
...
2.Connect the other end
of
the inlet
hose
to the inlet valve at the backside
of
the washing machine
and
fasten the
hose
tightly
clockwise.
when there is a inlet at the back
of
the
machine,it
must be connected to a
cold
water
supply.If there are two inlet
valve,one
is connected to a
cold water supply and the other is connected
to
a hot water supply.
Follow the indication
of
the picture
below
to complete the connection.
inlet valve
for
cold water
inlet hose
for
cold water
tAiU•ii-
•
If
there is any leakage with hose
after
the
connection,then repeat the steps to
connect
inlet hose.
• Do not bend the hose.
• Check
for
inlet hose connection carefully
before using the washer each time.
■
Connect
the
drain hose
• The drain hose shall be placed at a
height
of
65-100cm above the floor, otherwise, it
can cause poor drainage.
• You can use the supplied drain hose
support bracket to loop the drain hose
down into the wall,standpipe
or
laundry tub.
• Take care to ensure all hose connections
are tight.
tAiU·ii-
• The end
of
the drain hose cannot be
immersed in water for the washer to
work
properly.
8
inlet valve for hot water with a red grid
inlet hose for hot water with a red side
0
D
To Next Page
Loading...
