Install Washing Machine
We
recommend
that
your new washer should
to
installed by a qualified
appliance technician.If you feel that you have
the
skills
to
install the washer,
please read the installation instructions carefully before installing.
■
Tools needed
You
may need to have the following
tools
to
help
you in the installation
of
your washer:
•Scissors •Pliers •Standard Screwdriver
•Gloves •Spanner
■
Unpacking the washing machine
Unpacking
your
washing machine and check
if
is
there
any
damage during
the transportation.Also make sure
that
all the the
items(as
shown below)
in
the attached bag are received. If there is any
damage
to the washing
machine during the transportation.or
any
item is missing
or
damaged,please contact
the
local
dealer
immediately.
*If washing
machine
is not double inlet, the machine
does
not
have the hot inlet hose.
Inlet Hose
(Connect to cold
water supply)
0
Hot
In
let
Hose
(Connect
to
Hot
water supply)
■
Select
the
location
Drain Hose
Hole Cover (4EA) Support Bracket
(Used
to
plug transit (Used to loop the end
bo
lt holes) of drain hose)
Spanner
(1
.Used
to
adjust the bottom
of
the machine,
2.Remove the transport bolt on
the back
of
the machine)
Before installing the washer.the location characterized as follows shall be
selected:
-Rigid,dry,and level surface(if not level,please
make
it level with reference
to the following figure "Adjustable Leg").
-Avoid
direct
sun light.
-Sufficient ventilation.
-The
ambient
temperature shall be between 0-40°C.
-The
ambient
humidity shall be below
95%(When
the temperature is 25°C).
-Keep
far
away
from the heat resources such as coal
or
gas.Make sure that
the washer will not stand
on
power cord.Do not install the washer on the
carpet floor.
0
To Next Page
Loading...
