错误!未指定书签。
Page 23 of 27
Appendix ⑼ “Factory Menu Description”
1-Hotkey submenu
Enable Hotkey flag by pressing
“◄►” key to have possibility to
access Factory menu with
“RETURN” key (default is disabled)
Note: while USB as Serial port, the “Factory Key” is off, then you want to use the Serial port to debug the TV,
after you turn on the “Factory key”, you should switch off/on the TV, then you can connect UART interface to
suitable manufacturing TV.
2-Warm-Up Mode submenu
Enable Burning mode by pressing
“◄►” key
Press “Menu” key on local
keyboard to exit the Burning mode
3-ADC submenu(N/A - menu remains grayed)
4-White Balance submenu
Select by pressing “◄►” key
Select Tone by pressing “◄►” key
Set R Gain by pressing “◄►” key
Set G Gain by pressing “◄►” key
Set B Gain by pressing “◄►” key
Set R Offset by pressing “◄►” key
Set G Offset by pressing “◄►” key
(-127..+128 for offset)
Set B Offset by pressing “◄►” key
Press “►” key to initialize RGB
Gain/Offset values
Press “►” key to disbale all picture
settings from Feature submenu.
This should be done before any
White Balance alignment (flag is
restored to Off after Shop-End)
Press “►” key to activate submenu