35
and Limbs is 4.0 W/Kg averaged over 10 grams. Tests for SAR are conducted using standard
operang posions with the device transming at its highest cered power level in all
tested frequency bands.
This device is complied with SAR for general populaon /uncontrolled exposure limits in
ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement methods
and procedures specied in IEEE1528.
The FCC has granted an Equipment Authorizaon for this model device with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines. SAR informaon on
this model phone is on le with the FCC and can be found under the Display Grant secon of
www.fcc.gov/oet/ea/fccid aer searching on FCC ID: 2ACCJB112
Although the SAR is determined at the highest cered power level, the actual SAR level of
the device while operang can be well below the maximum value.
This is because the device is designed to operate at mulple power levels so as to use only
the power required to reach the network. In general, the closer you are to a wireless base
staon antenna, the lower the power output of the device.
Before a device model is available for sale to the public, compliance with naonal regulaons
and standards must be shown.
The highest SAR value for this model device when tested is 1.14 W/Kg for use close to the
body, and 1.57 W/Kg for Limbs.
During SAR tesng, this is set to transmit at its highest cered power level in all tested
frequency bands, and placed in posions that simulate RF exposure in usage near the body
with the separaon of 10 mm, and the Limbs with the separaon of 0 mm. Although the SAR
is determined at the highest cered power level, the actual SAR level of the device while
operang can be well below the maximum value. This is because the device is designed to
operate at mulple power levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless base staon antenna, the lower the power output.
Addional informaon on SAR can be found on the Cellular Telecommunicaons & Internet
Associaon (CTIA) Web site: hp://www.ca.org/
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protecon against harmful interference in a residenal installaon. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio communicaons. However, there is
no guarantee that interference to radio or television recepon, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
Changes or modicaons not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
For the receiver devices associated with the operaon of a licensed radio service (e.g. FM
broadcast), they bear the following statement: