18
Add the AC Unit to the Wireless Network using “AP Mode”
If connections to the wireless network fail using the “CF mode”, you can connect using the “AP
mode” (using the AC unit as a mobile hotspot).
1. On the App page indicating CF mode, click “AP mode” in the top, right-hand corner as
illustrated.
2. AP should show on the page as illustrated below. Press “Next Step” to continue.
3. To the switch the AC unit over to AP mode - Press “Display” on the remote control 6 times
within 6 seconds so the AC unit switches from “CF mode” to “AP mode”. Allow the unit 10-15
seconds to switch modes and AP will flash on the AC unit display screen when complete.
To Next Page
Loading...
Need help?
General
