2
Notice
1.Check whether the power voltage is the same as the voltage of the cleaner prior to
use.
2.Use clear water or mineral water and don’t use impure water as to avoid blocking
pipe.
3.Don’t put the hand directly under the nozzle port during use so as to avoid scalding.
4.Keep the external surface of the cleaner clean and dry. Don’t move the cleaner to
avoid the damage while using.
5.Check the water level of the external water source before starting the machine.
6.If the machine sounds beating after starting, please press the safety valve to clear.
Principle of Steam Cleaning
-Steam cleaning is to inject clear water into steam heating pressure boiler, then the
water is heated to steam in a complete sealing status. In the heating process, the
pressure in the boiler will gradually increase. When the pressure in the boiler reaches
over 3.5 bar, the steam cleaner enters into working state, the temperature of the
spraying saturated steam reaches over 135℃, use the high temperature and high
pressure of saturated steam to remove the attachments such as oil stain, sewage from
the surface of the parts and vaporize them away. At the same time, it can also clean
small gaps and holes, peel off and remove oil stains and residues to achieve
requirements for high efficiency, water saving, clean and dry.
To Next Page
Loading...