Teac A-H300 - Before Use; Operating Environment and Placement; UK Mains Plug and Wiring

Table of Contents
Connection...
Rear Panel Overvie
Speaker Connection
Front Panel Controls and Their
Functions...
Basic Operation...
Recording..
Remote Control Operation.
Al Direct Play Functior
Specifications.
Troubleshooting
Before Use
Read This Before Operating
@Place the amplifier on a hard flat
surface.
@The ventilation holes should not be
covered. Make sure there is at least 20
cm (8 inches) of space above and at
least 5 cm (2 inches) of space besides
the amplefier. Do not place CD player or
other equipment on top of the amplifier.
@ Avoid placing it in direct sunlight or
close to a source of heat. Also avoid
locations subject to vibrations and
excessive dust, heat, cold or moisture.
© Do not open the cabinet, as this might
result in circuitry damage or electrical
shock.
©@Do not attempt to clean the unit with
chemical solvents as this might damage
the finish. Use a clean, dry cloth.
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not
suitable for the power points in your
home or the cable is too short to reach
@ power point, then obtain an
appropriate safety approved extension
lead or consult your dealer.
If nonetheless the mains plug is cut off.
remove the fuse and dispose of the plug
immediately, to avoid a possible shock
hazard by inadvertent connection to the
mains supply.
If this product is not provided with a
mains plug, or one has to be fitted, then
follow the instructions given below:
IMPORTANT. DO NOT make any
connection to the larger terminal which
is marked with the letter E or by the
safety earth symbo + or coloured
GREEN or GREEN-and-YELLOW.
The wires in the mains lead on this
product are coloured in accordance
with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As these colours may not correspond
with the coloured markings identifying
the terminals in your plug proceed as
follows:
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter L or
coloured RED.
cover
IF IN DOUBT — CONSULT A
COMPETENT ELECTRICIAN.
ENGLISH