2. TV PLACEMENT SETUP
6
TV Stand Installation/Removal
Fall Prevention
To prevent the TV from tilting forward and falling over to cause damage or injury, please
secure the TV to your table or wall using screws or eyebolts and strong cord (not provided).
An example on fixing the TV to a table is shown below
1. Install a wood screw or eyebolt into the table that is supporting the TV.
2. Fix a machine screw into a screw hole near the base in the back of the TV.
Alternatively, secure the TV to the wall directly behind it by fixing eyebolts to the wall and
tying them to screws fixed on the centre of the TV back
panel.
3. Tie the wood screw or eyebolt to the machine screw with a strong cord.
Parts & Connections
USB Multimedia
Playback
TV Placement
Setup
Initial Setup &
Input Sources
Remote Control
On-Screen DisplayTV & Electronic
Programme Guide
Digital Video
Recording (DVR)
(OSD) Menu
Reference
1. Place the unit face down on a soft surface.
2. Gently position the base to the leg at the bottom of the TV.
3. Insert the column corresponding position with the threaded
screw size M5 * 45 fixed
4. Fasten the 5 provided screws (screw size B4x18F) to secure the
stand to the TV according to the diagram.
screw size M5 * 45
4
5
6
screw size B4x18F
To Next Page
Loading...
