Teac MT-20D-IO - Page 101

"BASIG"
(d) Simulator OE (TEAG Part No.
)
(hereinafter. referred to as SOE)
(e) DG power supply (+12 V. 2 A. and +5 V, 5 A)
(4) Exclusive jigs
(a) Reel motor jig
(b) FPT jig
(TEAG Part No. 17852575-00)
(TEAG Part No. 17852581-00)
(c) FPT check jig (TRAG Part No. 17952582-00)
(d) Roller height jig (TEAG Part No. 17853275-00)
(e) Tilt adjusting jig (TEAG Part No. 17853274-00)
(f) Height adjusting jig (TRAG Part No. 17852572-00)
(g) Gonnector jig (TEAG Part No. 17853041-00)
(5) Test tapes
(a) Work tape (TEAG Part No. 19800022-50)
(b) Mirror cassette (TEAG Part No. 14800093-00)
(c) Alignment tape (TRAG Part No. 14800090-10)
(d) Speed tape (TEAG Part No. 14800091-10)
(e) Hole sensor test tape (TRAG Part No. 14800087-00)
(f) Level test tape (TEAG Part No. 14800088-00)
(6) Consumables for maintenance etc.
(a) Gauze
(b) Adhesive (Cemedine's Hisuper)
(c) Screw lock (Three Bond's 1401G)
(d) Cable tie (TEAG Part No. 16362294)
(e) Screws and washers (refer to Table 504)
(f) TZ-380 (TEAC Part No. 17930340-00)
(7) Others
(a) Bulk eraser
(b) Head eraser
Note The measuring instruments and measuring tapes to be used should
have been calibrated properly.
- 4008 -