Teac MT-20D-IO - Page 100

4-1-4 Maintenance articles
The measuring instruments, jigs, and tools required for maintenance of MTD
are listed below.
(1) Measuring instruments
(a) Oscilloscope (two-channel trace type)
(b) Digital voltmeter (for measurement of DC voltage
(2) Tools
(a) Phillips screwdriver No. 0
(b) Phillips screwdriver No. 1
(c) Conventional type screwdriver, small size
(d) Torque driver 1.5 kg.cm
(e) Torque driver 2.5 - 4 kg.cm
(f) Hexagonal wrench 1.5 mm
(g) Nipper
(h) Radio pliers
(i) Tweezers
(3) Exclusive simulators and DC power supply
(a) Simulator OA (TEAC Part No. 19800020-00)
(hereinafter, referred to as SOA)
Remark
"D/CAS"
The model of SOA to be used should be Version 3.22 onwards.
The version of SOA is indicated to the display by keying in
EF command.
(b) Simulator OB (TEAC Part No. 19800021-00)
(herienafter, referred to as SOB)
"SCSI"
(Simulator OD (TEAC Part No.
(hereinafter, referred to as SOD)
- 4007 -
)