Why my Team Losi TEN SCTE does not operate?
If your Team Losi Motorized Toy Car isn't operating, the battery might not be charged or plugged in; charge or plug it in. The ESC switch might not be turned on; turn the ESC switch on. Alternatively, the transmitter might not be on, or the batteries might be low; turn it on or replace the batteries.
What to do if motor runs but rear wheels do not rotate on Team Losi Motorized Toy Car?
If the motor of your Team Losi Motorized Toy Car runs but the rear wheels don't rotate, it could be due to several reasons. The pinion might not be meshing correctly with the spur gear, so adjust the pinion/spur mesh. The pinion might be spinning on the motor shaft; in this case, tighten the pinion gear setscrew on the motor shaft. It's also possible that the transmission gears are stripped, requiring you to replace them. Finally, check for a broken drive pin and replace it if necessary.
Why does my Team Losi TEN SCTE have poor run time and/or sluggish acceleration?
If your Team Losi Motorized Toy Car has poor run time or sluggish acceleration, the battery pack may not be fully charged; recharge the battery. The charger may not be allowing a full charge, so try another charger. Also, the driveline may be bound up; check the wheels and transmission for binding.
How to fix steering that does not work on Team Losi Motorized Toy Car?
If the steering on your Team Losi Motorized Toy Car isn't working, ensure the steering servo plug is correctly connected to the receiver steering channel, paying attention to proper polarity. It's also possible that the servo gears or motor are damaged, requiring you to replace or repair the servo.
Why does my Team Losi Motorized Toy Car have poor range and/or glitching?
If your Team Losi Motorized Toy Car experiences poor range or glitching, check and replace the transmitter batteries if they are low. Recharge the vehicle battery if it's low. Also, check all wire connections and plugs for any looseness.
What to do if motor does not run on Team Losi TEN SCTE Motorized Toy Car?
If the motor of your Team Losi Motorized Toy Car doesn't run, it could be due to a damaged motor wire solder joint; resolder the motor wire with the proper equipment. Alternatively, the motor wire may be broken; repair or replace it as needed.
Why does the ESC get hot on my Team Losi Motorized Toy Car?
If the ESC in your Team Losi Motorized Toy Car gets hot, the motor may be over-geared; use a smaller pinion or larger spur gear. Additionally, the driveline may be bound up; check the wheels and transmission for binding.
What to do if my Team Losi TEN SCTE will not turn one direction?
If your Team Losi Motorized Toy Car will not turn in one direction, the servo gears may be damaged; replace or repair the servo.
Explains hazard levels using terms like NOTICE, CAUTION, and WARNING to indicate potential risks.
Instructions on registering your TEN-SCTE online to receive product updates and news.
Guidance on reading the manual and precautions before operating the RC vehicle.
Covers age recommendation, safe operation practices, and general warnings for the TEN-SCTE.
Explanation of peak detection chargers and their use for charging NiMH batteries.
Lists the tools included with the vehicle and other necessary equipment.
Outlines the essential steps for initial setup and operation of the TEN-SCTE.
Step-by-step guide for installing the motor onto the chassis.
Instructions for mounting the receiver and ESC using double-sided tape.
Detailed steps for installing and centering the servo and attaching the servo horn.
Includes break-in procedures, ride height, camber, toe-in, and electronic setup.
Essential safety tips to follow while operating the TEN-SCTE, including visibility and crowds.
Regular inspection points for keeping the TEN-SCTE in optimal condition.
Inspecting gears, and checking/rebuilding shocks for performance.
Importance of alignment (toe-in, camber) and battery tray positioning for handling.
Basic cleaning, inspection, and steps for maintaining differential performance.
Adjusting shock location, camber, and toe-in for optimal front end handling.
Adjusting camber link, toe-in/out, and differentials for front end performance.
Adjusting shock location, camber, toe-in, and ride height for rear end performance.
Instructions for checking and reglueing tires to the rims.
Detailed steps for draining, refilling, and bleeding RC shock absorbers.
Details warranty period, limitations, exclusions, and purchaser remedies.
Disclaims liability for special, indirect, or consequential damages.
Contacting support, submitting for inspection, and warranty/non-warranty repair processes.
Guidance on proper disposal of electrical and electronic equipment in the EU.
Detailed settings for front suspension components including toe, camber, caster, shocks, Ackerman, and bump steer.
Details on adjusting rear suspension components like toe, anti-squat, and shocks.
Specifying motor, ESC, and battery settings for optimal performance.
Diagram showing exploded parts of the chassis and related components.
Diagram showing exploded parts of the shock absorber assembly.
Diagram illustrating the assembly of wheels, tires, and beadlock rings.
Diagram showing the assembled chassis with wheels and tires attached.
General| Scale | 1/10 |
|---|---|
| Drive Type | 4WD |
| Type | Short Course Truck |
| Battery | Not Included |
| Chassis | 3mm |
| Suspension | Independent |
| Transmission | 4WD |
| Shock Type | Oil-Filled |
| Body | Short Course Truck |
To Next Page
