Tebco SUBURBAN - Page 82

82 OWNER’S MANUAL
The following checklist presumes a bicycle which
is assembled except for the handlebar & stem,
brake and gear levers, saddle and seat stem,
pedals, frame reectors and wheels.
• Fit wheels to frame and align. Secure axle
nuts or Quick Release (QR) mechanism.
• Lubricate handlebar stem, slacken wedge
bolt and wedge, slide into head set to
below minimum insert mark, align square
to front wheel, tighten wedge bolt. Tighten
wedge bolt. Check head stem lock nut is
tight and that the handlebar will not rotate.
• If your bicycle is equipped with a ‘threadless’
headset, check tting adjustments with your
bicycle retailer. DO NOT OVER TIGHTEN the
two securing bolts.
• Slide brake and gear lever assemblies onto
handlebar in correct conguration. Tighten
locking bolts. Adjust brake assembly cables
and align brake blocks for prescribed
clearance.
• Fit handlebar tape or handgrips, stop ends
to bar if bar is taped, and bell.
• Assemble saddle onto seat stem. Tighten
xing nuts.
• Lubricate seat stem and insert in seat tube
to below minimum insert mark. Tighten seat
binder bolt or Quick Release mechanism.
• Fit pedals to crank in correct order; pedal
marked R on the right hand side; L on the
left.