Tecdesk 1000 - CUSTOMISING YOUR SOUNDS; VOICE CALL RING; VOLUME; KEY TONE

11
CUSTOMISING YOUR SOUNDS
In Standby mode press the [ OK ] button to enter into the MAIN MENU to access the “SOUND” and “SETTINGS”. Use the [ ][ ]
buttons to toggle between the 2 options and select “SOUND”. Press the [ OK ] button to conrm. In the “SOUND” submenu, you can set
the “VOICE CALL RING”, “VOLUME”, “BUTTON TONE” and “WARNING TONE”. Use the [
][ ] button to toggle between the options
and press the [ OK ] button to make the selection.
VOICE CALL RING
Press the [ OK ] button to enter into “VOICE CALL RING” option. Use the [ ][ ] buttons to toggle between the ringtones. Press
[ OK ] button to select the ringtone. Further options enable the ringtone to be played. Ensure the ringtone is saved by going to the
“SELECT” option.
VOLUME
Press the [ OK ] button to enter into “VOLUME” option. Use the [ ][ ] buttons to increase or decrease the volume.
Press the [ OK ] button to save the setting.
KEY TONE
Press the [ OK ] button to enter into the “KEY TONE” option. Use the [ ][ ] button to enable or disable the keypad tone.
Press the [ OK ] button to save the setting.
WARNING TONE
Press the [ OK ] button to enter into the “WARNING TONE” option. Use the [ ][ ] buttons to enable or disable the warning tone.
Press the [ OK ] button to save the setting.