28 EN
EN17092-6:2020
T6508120
INTERNATIONAL
XL
C U
19. Support
In case of questions or should the users need further information, they may first contact
Tech-Air
®
Dealer where the System was purchased, or Alpinestars directly:
E-mail: techairsupport@alpinestars.com Tel: +39 0423 5286 (asking for Tech-Air
®
Support)
20. Certification Information
The System is manufactured by:
Alpinestars SpA
5, Viale Fermi – Asolo (TV) 31011 Italy
And it is covered by a number of certifications.
Personal Protective Equipment
The System is a Category II certified PPE (Personal Protective Equipment) under European
Regulation (EU) 2016/425 and under Regulation 2016/425 on Personal Protective Equipment,
as brought into UK law and amended. EU Type examinations have been conducted on this
product by the Notified Bodies below.
As an impact protector garment, the standard EN 17092-6:2020 has been applied;
The EU examination was conducted by:
Notified Body #2008 Dolomiticert S.C.A.R.L., Zona ind. Villanova 7/A, 32013 Longarone (BL),
Italy
- Protective garments for Motorcycle Riders (EN 17092 – 6: 2020)
Level of Performance and Mechanical Requirements for each Protection Class
The Technical Standard EN 17092:2020 requires that motorcycle protective garments have
to fulfill with mechanical requirements according to the relevant class of protection set
forth by the Technical Standard EN 17092:2020.
The following requirements are established for the most exposed areas (i.e. shoulders,
elbows, hips, knees) as follows:
Applied Standard:
EN17092-6:2020
Garment Size
Impact Protection
Garment (C), Use as
Under garment (U)
PRODUCT
Reference Name
Name of the
manufacter
To Next Page
Loading...