Geng Started
To get setup and using your TI52 Bluetooth speaker please f ollow the
quick two step guide below;.
Step One:
Your TI52 will be supplied with some charge, s o you can start using it
straight away. Carefully remove from the box and POWER ON the
to flash BLUE. The blue indicang represents the speaker is searching
for an external device.
Step Two:
To pair a Bluetooth connecon with the TI52 speaker you must have
a Bluetooth enabled device to connect and stream music from such
as a smart phone. Using your selected external device follow the
correct steps to open and search Bluetooth devices in range. Find,
Select and Connect to your speaker which will be labelled in your
search as TI52. Once a connecon has been established the
buon will beep and turn constant BLUE. Your audio
data from your connect device can now be wirelessly streamed and
synchronised with the TI52 Bluetooth speaker.
Please note: If the Bluetooth connecon is stable when speaker is
turned off, the sp eaker wil l automacally connect to the last
connected device.
Alternave AUX connecon: If you wish to make a direct audio
connecon please use the 3.5mm cable supplied to connect your
external device to the TI52 Bluetooth speaker.
For more detailed instrucons please refer to General operaons on
the follow pages.
To Next Page
Loading...