1
Welcome!
Thank you for purchasing 3.5 Channel Mega Helicopter. Please store this manual in a safe place for
future reference.
GETTING STARTED
• Remove the unit from the box.
• Remove any packaging from the product.
• Please read all instructions and retain all packaging until you have checked and counted all of
the parts.
PACKAGE CONTENTS
• 3.5 Channel Mega Helicopter
• Remote Controller
• Wall Charger
• Main Blade (2pcs) & Tail Blade (1pce)
• Instruction Manual
1. Instructions to assemble the Controller
Install antenna on top of the controller by twisting it clockwise. Install 6 x “AA” batteries (not included) in the battery
compartment of the controller as indicated below. (Pic 1)
Notice:
1. Install the battery as per the indicated polarity.
2. Do not mix new and old batteries.
Note: Prior to flying your helicopter for the first time,
fully charge the battery to ensure best performance.
2. Battery Charging Instructions
1. Connect the wall charger cord to the helicopter
battery input (see pic 2)
2. Plug the Wall Charger into the standard wall socket.
3. The red LED light will turn on while charging. After
the battery is fully charged, the LED light will turn
green. At this time, unplug the wall charger.
4. Connect the input jack of the battery to the socket
of the helicopter. (Pic 2)
5. The helicopter can be flown for approximately 6-8
minutes at full charge. It may take up to 80-120
minutes to fully charge the helicopter. (Fly time may
vary, depending on the individual handling).
To Next Page
Loading...