TECH ST-85 - II.D) Manual Mode

ST-85 – USER'S MANUAL
II.d) Manual Mode
For your convenience, the regulator features a manual mode module. In
this mode, each individual actuator is enabled and disabled independently of
the other. In addition to the Manual Mode function, the Blow Force
function has been provided.
This function allows you to set the blow force of the fan while in the
Manual Mode.
Pressing the ENCODER activates the fan. The fan will operate until the
ENCODER is pressed again.
Press the ENCODER to enable / disable the central heating pump.
Press the ENCODER to enable / disable the (water heater) hot
consumption water pump.
Press the ENCODER to enable / disable the alarm.
- 10 -
C.H. Pump
H.C.W. Pump
Fan
C.H. Pump
H.C.W. Pump
Alarm
Blow Force
Fan
20%
Blow Force
Blow Force
Fan
42
O
c | 55
O
c
C.H. Setpoint *