ST- 85 – USER'S MANUAL
setting the appropriate value, confirm it by pressing the encoder knob.
➢ FLUE GASES SCREEN
The following items are displayed, starting from the left: current C.H.
temperature, current flue gases temperature and blow power in percentages.
This view is used for monitoring current boiler parameters.
II.j) Language
With this function, you can select the language of your controller.
II.k) Factory Settings
The regulator has been pre-configured. However, it should be adjusted to
your individual needs. It is possible to return to the factory settings at any
time. By enabling the Factory Settings, all existing boiler settings will be
replaced by settings made by the manufacturer. From then on, you can again
set your own operating parameters for the boiler.
II.l) Fitting parameters
Access to fitting parameters is disabled for the user. This special view
contains advanced parameters accessible only by the manufacturer.
- 15 -
Fixed C.H. Pump
Factory Settings
Yes
No
23
O
c | 55
O
c
Setpoint
H.C.W. SCREEN
To Next Page
Loading...