18
Reset
After having reset the keypad, the user code, the admin
code, and other settings will be restored to default set-
tings.The RFID tags that have been registered will not be
deleted from the keypad.
1. Enter Setup mode.
2. Type [987654321#].
3. You hear one beep: the setup is suc-
cessful.
FAQ
Low battery Change the battery
No response from the
keypad
The batteries‘
positive and negative
terminals are
reversed.
Remove and insert
the batteries again
according to the
instructions in this
manual.
The keypad is locked
Press Arm or Home
Mode on the keypad
to unlock it.
The keypad cannot
be registered to the
control panel
No response from the
alarm panel
Make sure the alarm
panel is on.
Make sure the alarm
panel is in Connection
Mode.
To Next Page
Loading...