The inspection requires professionals and professional equipment to avoid
electric shock)
Battery high temperature or low temperature protection, please refer to the
corresponding method.
AC can not
Charge (TX-
231(
1. Please check that the AC cord is connected.
2. Please check whether the AC socket is normal and whether the AC mains is
normal; (Note: The inspection should be operated by professionals and
professional equipment to avoid electric shock)
3. Please check whether the reset switch pops up, if so, press the red button to
restore.
4. Battery high temperature or low temperature protection, please refer to the
corresponding method for handling.
Check that the AC switch is on. (On: the green indicator light on the button is on,
off: the indicator light is off)
Check whether the load device is connected to the AC output
The equipment is overloaded or short-circuit protected. After reducing the load or
eliminating the fault, it can be restored after restarting.
Battery under-voltage protection, need to be charged before use; AC switch should
be turned off and then turned on.
The reset switch pops up due to overload, and the load needs to be reduced. Press
the red button to restore TX-231 only
Cigarette
lighter, DC
Ports, USB,
TYPE-C no
output
Whether the DC switch is on. (On: the green indicator light on the button is on, off:
the indicator light is off)
Check whether the green indicator on the switch button is flashing. If it flashes, it
may be caused by overload or short circuit or over temperature of the DC module.
After checking and troubleshooting, it can return to normal.
Overload recovery: reduce the load to within the rated range,
Short-circuit recovery: check the load equipment and eliminate the short-circuit
fault,
Module over-temperature recovery: suspend use and resume after cooling.
Battery under-voltage protection, need to be charged before use
Battery high temperature or low temperature protection, please refer to the
corresponding method
LED light does
not light up
Whether the LED switch is on. (On: the green indicator light on the button is on,
off: the indicator light is off)
Battery under-voltage protection, need to be charged before use
Battery high temperature or low temperature protection, please refer to the
corresponding method
Battery high temperature or low temperature protection, please refer to the
corresponding method
If the battery is seriously short of power, charge it through the battery rescue port
until the LCD screen is lit, and then fully charge it in the usual way
To Next Page
Loading...
Need help?
General
