5
IR Distance: (set the distance of infrared induction): [Near] / [Middle] (default)
/ [Far]. Select and press OK button to confirm.
Note: Maybe you have to adjust the right option for your personal use.
Sensitivity Motion Sensors options: [Low] / [Middle] (default) / [High].
Select and press OK button to confirm.
Test the sensitivity and find the correct detection zone for your purpose. Set
the sensitivity of the sensor. Note: The temperature can also influence the
sensor sensitivity.
Low
Set the sensitivity to low if you want to record indoors (small
environment) or in cold environment.
Middle
Set the sensitivity to middle if you want to record outdoor (normal
environment).
High
Set the sensitivity to high if you want to record outdoors (huge
environment) or the temperature is mild.
Target Recording Time
Set the target recording time of the
day. With this option you can
preselect when recordings should
been taken.
As shown in right picture, you can set
the start and stop time. The camera
will work just in the set time slot. In
other time, the camera will keep in
standby state.
Options: [On] / [Off] (default). Press OK to confirm.
Note: If start time and stop time are the same, the working time is 24 hours.
Time Lapse Recording
Set the interval time of taking
pictures. The camera will take
pictures automatically as per set time
interval. For example, set the interval
time to 1 hour, the camera will take a
photo each hour. If you want to
observe that a plant blooms, the
camera will take 24 photos in 24
hours to record the whole process of
blooming.
Options: [On] / [Off] (default). Press OK to confirm.
Target recording time
： ：Start Stop
： ：Hr Min Hr Min
00 00 00 00
MENU Back OK Select
Set time lapse
： ：
Hr Min Sec
00 00 30
Notification:Motion
sensors deactivated
MENU Back OK Select
To Next Page
Loading...
Need help?
General
Weight and Dimensions
