Modes
Pin seeker mode
Especially for golfing, this mode is very useful. To measure the distance to the
pin flag, activate this mode. The flag will be tracked and isolated from the
background. Move the target centre around the pin flag while scanning. The
flag distance will be measured exactly.
Press the power button shortly and the distance value will be displayed. Hold
the power button and continuously measuring around flagpole until the value
is stable. This value is the distance to the flagpole.
Fog mode
Thru the fog, you will not be able to measure distant targets because the fog
will reflect the laser. This mode will filter the reflected laser within the first 30
meters. Now the measure of the distance is not caused by errors by fog
reflecting lasers.
Short press the power button to measure in fog mode the distance to an object.
Speed mode
For speed measuring of moving objects, ranging is measured twice. Two
distance difference, divided by the time interval of the two ranging
measurements, the speed of moving objects can be obtained.
Aim at the object and short press the power button. Keep aiming at the object
while it moves towards you or away from you until the speed value displays on
the screen.
Troubleshooting
Q: The device cannot be switched on
A: Battery may be empty. Replace the 2 AAA batteries with new ones.
Q: Can I use rechargeable batteries?
A: Yes, rechargeable batteries are useable.
Q: The measured value can’t be displayed
A1: Be sure the laser emission and receiving lens is clean.
A2: The measuring range of the rangefinder could be influenced by the angle
of the targets. Be sure it can reflect the laser towards the rangefinder.
Q: The speed measuring can’t be displayed
A: The to be measured target should be moves towards you or away from you.
To Next Page
Loading...
Need help?
General