3
Power supply
→ Insert 12x pieces of 1.5V AA batteries* (*included) in the correct polarity before
first use. → Open the battery compartment on the left (12) to insert 4xAA batteries.
Remove the battery cover on the right to insert 8xAA batteries.
Extended Information for Power supply
⚫ The device does not work with a battery voltage lower than 4V.
⚫ You can use rechargeable batteries. Attention: Shorter working time!
⚫ If you use the DC Jack as power supply the inserted batteries will not be charged.
Please remove the batteries from the device.
⚫ The battery life using standard non-rechargeable AA batteries with default time
lapse photo mode and a period of 5minutes will be: about 6 months with
288photos/day (12xAA batteries installed).
Inserting the memory card
⚫ The camera has no built-in memory, therefore insert a formatted MicroSD card**
up to 512GB (**not included) for saving files. We suggest to use class 10 or higher.
Attention: Do not insert the MicroSD card forcibly; refer to the marking on the
camera. The MicroSD card should have same temperature like the ambient
temperature.
⚫ If the capacity of MicroSD card is full, the camera will stop recording automatically.
⚫ Press the edge of the card gently to pop-out the MicroSD card.
Info: ⚫ Cards up to 32GB must be formatted in FAT32.
⚫ Cards of 64GB or more must be formatted in exFAT.
To Next Page
Loading...
