9
TX-186, 5000, 09/22
Note: 32GB USB devices have to formatted in FAT32. Above 32GB storage
it have to be formatted into exFAT format. Maximum storage size is 128GB.
Belt drive installation / repair
1. Use a screwdriver to remove the c-shape locking clip from the rotation
axis.
2. Lift the turntable plate up and remove from the axis of rotation (you will
find the driving belt detach from the track of the turntable.)
3. There are two small cylindrical pins on the back of the turntable plate for
the help of belt replacement. Place the belt on the track and hook the belt
to one pin.
4. Place the turntable plate back on the axis and make sure that the space
formed by pin and belts is aligned with the metal pin on the turntable
bracket, so that the metal pin on the turntable bracket, so that the mental
pin will stand in a triangular space when the turntable plate is fully back
on.
5. Manually rotate the turntable for about half-turn and the belt will be
positioned. Finally put the clip back on the shaft.
FAQ’s
Device will not power on
Make sure that the unit’s power cord is connected to an appropriate
electrical outlet and the wall socket is switched on.
There is no sound
Rotate the power/volume knob clockwise to increase the volume.
The vinyl record will not play
Make sure the function knob is set to you desired function. Make sure
you have selected the right speed (33, 45 or 78 RPM).
Nothing will play via the AUX IN connection
Make sure the cable is firmly connected and check if external device is
clean and undamaged. Check the function knob is set to your desired
function. Check that volume of external device is at 70-80%.
To Next Page
Loading...
Need help?
General
