Use of the device
Open back cover, insert MicroSD card.
Note: If no MicroSD card is inserted or the MicroSD card cannot read, the
Indicator LED 3 will be steady on.
Switch & indicator LED description
Motion detection video recording
Set switch 3 to V and set switch 2 to VGA (640x480) or FHD (1920x1080) to
choose video resolution, then set switch 1 to MD (LED 2 / BLUE light flashes
6x then off).
The camera turns on and videos will be recorded according to your setting.
Set switch 1 to OFF, the camera turns off and stops taking videos.
Note: Maximum file length of video recording is 15 seconds for VGA and FHD
resolution, after that a new file is created.
Motion detection picture taking
Set switch 3 to P, then set switch 1 to MD (Led 2/blue light flashes 6 times
then off), the camera will take photos (no matter of the position of switch 2).
Picture will be taken in every second motion is detected.
Set switch 1 to OFF, the camera turns off and stops taking pictures
Infra-Red Mode (IR)
the infrared light turns on automatically if the illumination is less than 10
LUX under video recording or pictures taking mode.
If the automatic IR light is on, it will remain on until the brightness is higher
than 70LUX, then the IR light turns off automatically.
If the automatic IR light is off, it will remain off until the brightness is below
10 LUX, then it turns on automatically.
So when the lumen is between 11–69 LUX, the state of the automatic IR light
depends on the initial automatic infrared switching state.
Recording while charging
5 seconds after this device is connected with an adapter, the same
operations are valid as for battery use.
To Next Page
Loading...
General