Need help?Do you have a question about the Techne FB-08C and is the answer not in the manual?
General| Brand | Techne |
|---|---|
| Model | FB-08C |
| Category | Laboratory Equipment |
| Language | English |
Provides an overview of Techne fluidised baths and their safe operation.
Lists critical cautions for operating fluidised baths safely, including temperature hazards.
Outlines safety procedures for maintaining the fluidised bath, emphasizing disconnection.
Highlights key operational considerations like risk assessment and airflow.
Details high temperature dangers and essential safety practices for operators.
Emphasizes the need for trained personnel and adherence to manual instructions for safe operation.
Provides step-by-step instructions for safely installing the fluidised bath, including power and earthing.
Describes the diverse applications of the FB-08C, including calibration and testing of sensors.
Highlights specific warnings for operators regarding fluidisation, alumina, and fume extraction.
Details safety requirements during the installation phase of the fluidised bath.
Covers essential safety points during the operation of the fluidised bath.
Outlines safety considerations for performing maintenance on the unit.
Provides guidance on safely handling and using the alumina fluidising medium.
Explains the necessity and safe implementation of fume extraction systems.
Lists key performance parameters including temperature range and stability.
Specifies the necessary pressure and flow rate for the compressed air supply.
Provides detailed measurements and weight specifications for the unit.
Instructions for connecting the fluidised bath to the main electrical supply.
Guidance on connecting the unit to a suitable compressed air source.
Details on mounting the unit on a firm surface and ensuring it is level.
Steps for correctly filling the bath with the fluidising alumina medium.
Information on the main power switch, fuse location, and their functions.
Explains how to use the temperature controller to set and monitor bath temperature.
Details on adjusting the fluidisation air flow using the dedicated control valve.
Instructions for operating the dust extraction system for a cleaner environment.
Description of the indicator lamps that show system status and operation.
Procedure for powering on and preparing the fluidised bath for operation.
Guidance on calibrating thermal sensors using the fluidised bath's stable environment.
Explains the dead bed technique for enhanced temperature stability during calibration.
Details on the automatic system that adjusts airflow based on bath temperature.
Routine checks and cleaning procedures to be performed daily or as needed.
Scheduled inspections for alumina condition, heaters, and air supply filters.
Identifies common causes and checks for issues related to poor fluidisation.
Addresses common problems with temperature control and potential causes.
Troubleshooting steps for issues with power, controller illumination, and air supply.
Instructions for safely draining the alumina fluidising medium from the bath.
Step-by-step guide for replacing the unit's thermocouple.
Procedure for accessing and replacing the internal heater elements.
Instructions on how to remove and replace the main temperature controller.
Guide for accessing and replacing the particle and oil filter elements.
Steps for replacing the porous plate if it becomes blocked or damaged.
Details accessories that are supplied with the unit as standard.
Lists optional accessories like probe holders, regulators, and compressors for the FB-08C.
To Next Page
