EG
14
The air intake grille can be removed in order to wash it with
water.
● Never use solvents, or harsh chemicals when cleaning the
indoor unit. Do not wipe the plastic casing using very hot
water.
● Some metal edges and the vanes are sharp and may
cause injury if handled improperly; be especially careful
when you clean these parts.
● The internal coil and other components of the outdoor
unit must be cleaned every year. Consult your dealer or
service centre.
CAUTION
HOW TO REMOVE THE AIR INTAKE GRILLE (ONLY
FOR MP-CA MODELS)
●
With the air intake grille open all the way, grip both
arms with your hans and pull toward you to remove.
●
To remount, hold the air intake grille roughly horizontal
and push it in until the arm shafts fit into the indenta-
tions in the main unit, then fit the front panel into place.
MP
MODELS
CA MODELS
GRILLE
STRING
●
Detach the safety string from the frame (remember to
attach it again after cleaning or maintenance).
●
Open the air intake grille
, hold it on and pull it toward
you to detach the two guides.
Arm
Air intake
grille
Washing the grille with water
●
Clean the grille gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
●
Neutral detergent may be used to remove stubborn
dirt. Then rinse thoroughly with water and wipe away
any remaining moisture.
CONDENSATE
DRAIN PAN
The inspection or replacement of internal components
involve the removal of the condensate drain pan.
Some metal edges and the vanes of heat exchanger are
sharp and may cause injury if handled improperly; be
especially careful when you clean these parts.
CAUTION
HOW TO REMOVE THE CONDENSATE DRAIN PAN
RUBBER CORK
CONNECTORS
CLIPS (2)
SUPPORT
PLATE (2)
SCREW (4)
SPECIAL SCREW (4)
1.Open the air intake grille.
2.Drain the condensate water into a bucket trough the
rubber cork that should be soon closed.
3.Remove the frame-grille assembly by loosening the four
special screws with washer; you can utilise the two clips
that fix the frame to the unit.
4.Disconnect the electrical connectors between the frame-
grille assembly and the unit.
5.Remove the four screws of the two support plates.
6.Grasp the two support plates, remove with care the
condensate drain pan and clean it inside, if necessary.
7.Once finished the maintenance, reassemble the pan,
aligning the side with the hole for condensate drain and
the side with the pump; insert the connectors of the unit
into the proper hole in the pan.
8.Fix again the four screws of the support plates and the
frame group aligning the corner from which the wires exit
and the corner with the connectors of the unit.
9.Mount the air intake grille along with the filter; be sure
that the safety string has been attached and that the latch
screw has been fixed on both sides.
ADDITIONAL MAINTENANCE (ONLY FOR CA MODELS)
To Next Page
Loading...
