13
EG
Set vertical vanes to the front position during
COOLING/DRY operation if humidity is high.
If the vertical vanes are set to the left-most or right-most
position, condensation will form around the air outlet
and drip off.
CAUTION
(ONLY MP - MT - KPA - K MODELS)
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION selector with a pen until the OPERATION
lamp is turned off - K MODELS: press the OPERATION
buttun (ON/OFF).
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after 3
minutes.
NOTE
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired mode
(COOL or HEAT) - K MODELS: press the OPERATION
buttun (ON/OFF).
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
NOTE
MP
MODELS
OPERATION
selector
OPERATION
selector
MT MODELS ONLY
KPA MODELS
OPERATION
selector
CA
MODELS
OPERATION
selector
OPERATION
selector
SDA / DSA MODELS
K MODELS
OPERATION button (ON/OFF)
OPERATION lamp
CARE AND CLEANING
●
Maintenance operations must be carried out by specially
trained personnel.
●
For safety, be sure to turn the air conditioner off and also
to disconnect the power before cleaning.
●
Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
WARNING
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
When cleaning the grille, be careful not to force the vanes
out of place.
To Next Page
Loading...
