EG
15
AIR FILTER
The filter behind the front panel should be checked and
cleaned at least once every two weeks.
MP-MT
-KPA-K MODELS
1.Grasp both ends of the air intake grille and pull to open
it.
2.Hold the air filter by the tab and pull it upward. Clean the
air filter.
3.When replacing the filter, make sure that the FRONT
mark is facing you. Reinsert the filter into place and close
the air intake grille.
2
1
KP
A MODELS
3
MP-MT MODELS
HOW TO REMOVE THE FILTER
1. Grasp both ends of the air intake grille and pull it towards
you and up.
2. Push the filter up slightly, and then pull it down. Clean the
air filter.
HOW TO REPLACE THE FILTER
1. With the «FRONT» mark facing you (if present), slide the
filter up into the unit and insert it in its place.
2. After installing the filter, close the air intake grille.
Front panel
Air filter
Front panel
Insert into the groove on the unit
Air filter
1.Remove the screw on each side out of the latch using a
screwdriver.
2.Press on the two latches of the air intake grille with your
thumbs in the direction of the arrow to open the grille.
3.Open the air intake grille downward.
4.Remove the air filter from the air intake grille. Clean the
air filter.
5.Insert the filter correctly again inside the grille, close the
grille letting the latches slide toward the outside and fix
again the latch with the screw on both sides.
HOW TO REMOVE THE FILTER
LATCH
SCREW
AIR INTAKE GRILLE
AIR FILTER
CA
MODELS
SDA
MODELS
The air filter should be cleaned at least once every six
months or more frequently; it depends on the real operation
conditions.
CA-SDA-DSA
MODELS
1.Remove the screw.
2.Remove the filter and clean it.
3.Insert the filter again and fix the screw.
K MODELS
Front panel
Air filter
1.Open the front panel pushing on the two points “PUSH”
and then pulling towards you.
2.Remove the air filter as shown in the figure. Clean it.
3.Replace the filter and close the front panel.
To Next Page
Loading...
