138
6-1 PRESENTATION
The remote controller can be used for:
9 display of the current heat pump status (Set point, heating/cooling mode, On/off),
9 display of possible frigorific circuit alarm,
9 display of alarms history,
9 display of frigorific circuit sensors values and current information about compressor speed, compressor current & valve
position,
9 display and modification of parameters,
9 heat pump control in stand alone configuration (without system control).
Reference of the remote controller: RCS-TM 80BG (K70D052Z)
Configuration:
View from backside
Settings to be
checked before use
To Next Page
Loading...
