Technics DC SERVO SL-BD20D - Page 5

Adjustment
automatic-return |
Make this adjustment if the tonearm doesn't return auto- This adjustment is preset at the factory. This adjustment should
matically to the arm rest, or if it returns before the tune ends. not be necessary unless the cartridge or stylus is changed.
1. Adjust to tre desired automatic-return position. = -1. Set the cueing contralto" ¥™.
2. Check to be sure the automatic-return position is correct. 2. Move the tonearm to a position above the disc.
3. Adjust the stylus tip positon.
Remove the
rubber ca
ee
il AN |
- Adjustment screw :
| Auto-return adjustment screw I |
The plug-in type of cartridge is already designed to match this If noise [s heard from new discs, the stylus is probably worn.
unit in every respect: weight, correct stylus pressure, stylus tip Replace it with a new one.
position, center ofgravity, etc. This means that there’s no longer @Stylus fife... cece ee eee eee eee approx. 1000 hours
any need for troublesome connection of lead wires or New Stylus. .... 06.00 ee eee eee ee ee ee en we en EPS-34CS
adjustment of the stylus pressure. Preparation:
Refer to the section on “Replacement of the cartridge”, remove
the screw and pull out the cartridge.
@ insert the new cartridge by
following the steps in
reverse order,
Insert the new stylus, along this side,
Deing careful not to touch the stylus tip.
“Maintenance
of
external
surfaces.
Use a soft brush or simifar material to gently remove the dust. To ciean this unit, use a soft. dry cloth.
Thoroughly clean your discs occasionally with a high-quality lf the surfaces are extremely dirty, use a soft cloth, dipped intoa
disc cleaner. soap-and-water solution or a weak detergent solution.
WrlIng the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, nor a chemically
treated cloth to clean this unit.
—5— Suchchemicals may damage the finish of your unit.