Technics EAH-F70N

Preparation
10
Connecting a Bluetooth
®
device
1 In the power-off state, press and hold [Í/I ( )] of this unit until the power/pairing LED
blinks.
• This unit will start to search for a Bluetooth
®
device to connect to, and the power/pairing LED will light alternately
in blue and red.
2 Turn on the power of the Bluetooth
®
device, and enable the Bluetooth
®
function.
3 Select “EAH-F70N” from the Bluetooth
®
device’s menu.
• A MAC address (an alphanumeric character string that is displayed by
and unique to the device) may be displayed before “EAH-F70N” is
displayed.
• If prompted for a passkey, input the passkey “0000 (four zeros)” of this
unit.
4 Check the connection with the Bluetooth
®
device on the
unit.
• The power/pairing LED will light alternately in blue and red until the connection with the device is completed.
When the power/pairing LED (blue) blinks twice every approx. 2 seconds, pairing (registration) is completed.
(Connection established)
Note
• If connection to a device is not established within approximately 5 minutes, the unit will be turned off. Perform pairing
again. (Except for when noise cancelling is turned ON.)
• You can pair up to 8 Bluetooth
®
devices with this unit. If a 9th device is paired, the device with the oldest connection
will be replaced. To use it, perform pairing again.
Preparation
• Place the Bluetooth
®
device within approx. 1 m (3.3 ft.) from the unit.
• Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
®
device for connection
When pairing a device for the first time: approx. 3 seconds
When pairing a second or subsequent devices: approx. 5 seconds
Bluetooth
Bluetooth ON
EAH-F70N
Device
e.g.
Select