FM outdoor antenna
(not included)
75 _ coaxial cable
(not included)
(_) Remove a piece of the outer
vinyl insulator.
20 mm (25/a2")
(_) Twist the shield braid
to expose the core
wire.
Shield braid 10 mm (3/8")
(_) Connect the shield braid and the
core wire as shown at left.
.
AM AI_
AMLOOPANT
Vinyl-covered wire
(not included)
J ,
AM loop antenna
(included)
[]
An outdoor antenna should be used when using this unit in moun-
tainous areas or in spaces enclosed by reinforced concrete where
the FM indoor antenna (included) does not provide satisfactory
reception.
Disconnect the FM indoor antenna if an FM outdoor antenna is
installed.
An outdoor antenna should be installed by a qualified technician
only.
[]
An outdoor antenna should be used when using this unit in
mountainousareas or in spaces enclosed by reinforcedconcrete
wherethe AMloopantenna(included)doesnot providesatisfactory
reception.
Stretch 5-12 m (16-40 ft.) of vinyl-covered wire horizontally across
a window frame or other convenient location, keepihg it as high as
possible from the ground.
When the unit is not in use, disconnect the outdeor antenna to
prevent possible damage that may be caused by lightning. Never
use an outdoor antenna dudng an electrical storm.
Be sure to connect the AM loop antenna even when an outdoor
antenna is used.
To Next Page
Loading...
