Technics SA-AX920 - Making Recordings; Recording 6 Channels; Tape Deck Recording Procedure; VCR Recording Procedure

INPUT SELECTOR
""°'''"''"''''"°°''"°°""°°°''''"'"'"°'°'''"°'°''''''''"°'°"
JR. VCR 2 /F_
Jl. W/DSS
When you selectDVD 6CH INPUT mode, onlysound from the front
leftand rightspeakersisrecorded.
To record all 6 channels
Set the playback mode on your DVD player or decoder to 2 channel
(stereo) mode.
For details, see the instruction manual that came with the connect-
ed equipment.
[]
Before recording, prepare the tape deck for recording (recording
level adjustment, etc.).
See the tape deck's operating instructions for details.
i
ml. Turn INPUT SELECTOR to select the source
to be recorded.
Any source can be selected except TAPE.
J
m
(only if you select TV/DSS/VCR 2 in the above step)
Set ".._ VCR 2" or "a. "rV/DSS" position.
Begin recording on the tape deck.
Follow your tape deck's operating instructions.
I_! Begin the source to be recorded.
=ollow your equipment's operating instructions.
_''/' i .... f'_ _i_ _ ¸ ' ........ _
/
0 o o o o o o o
VCR 2 _e_'minals
m'°_°'''o'°°°''''o'P°'''''''°'°''''°'*''D''°''''''°''''''''°'°'''''''''''I i
VCR2
II TV/DSS
Before recording, prepare the VCR 1 (VCR) for recording (recording
level adjustment, input selector setting, etc.).
See the VCR's operating instructions for details.
O Turn INPUT SELECTOR to select the source
to be recorded.
AnysourcecanbeselectedexceptVCR1 (VCR)andTAPE.
m
Recording from the tape deck is not possible.
(only if you select TV/DSSNCR 2 in the above step)
Set "_._ VCR 2" or" J_ TV/DSS" position.
Begin recording on the VCR.
Follow your VCR's operating instructions.
Begin the source to be recorded.
Follow your equipment's operating instruction_,_ ..-
• ...o........... ,=.........o. ,,...,. ,..=_....,.o.. ,,.......................o.o...
For your reference
There are VCR 2 terminals at the front of this unit.
It is easier to carry out dubbing from a camcorder if it is connected
to the front terminals.